FixGrid AI
GE · Dishwasher · Model GDT695SSJSS

GE GDT695SSJSS DIY Repair Guide

Standing water, dirty dishes, or a puddle on the floor? Fix It Yourself with Confidence.

Easy 20–60 minMaya AI live in your pocket
Start guided diagnosis

30-day model-specific access · cancel anytime · works on phone & desktop

Safety first — lockout / tagout

Cut power at the breaker before pulling the dishwasher. Shut off the water supply under the sink before disconnecting any hose.

Tools you'll need

  • Torx T-15
  • Towels
  • Sponge
  • Flashlight

Step-by-step repair flows

Pick the symptom that matches what your GE GDT695SSJSS is doing right now. Each flow ends in a parts list and an option to escalate if it's beyond comfortable DIY scope.

Symptom

Standing water in the tub at end of cycle

Filter, then drain hose, then pump — in that order. 70% of 'won't drain' is a filter that's never been cleaned.

Diagnostic flow

  1. 1

    Remove and rinse the filter assembly

    Twist the upper cylinder counter-clockwise, lift out, then lift the lower mesh. Rinse under hot water — every 30 days as routine.

  2. 2

    Bail the standing water

    Use a sponge / turkey baster until the tub bottom is dry.

  3. 3

    Inspect the drain hose loop

    Under the sink, the hose must loop ABOVE the disposal inlet (high-loop) to prevent backflow.

  4. 4

    Test the disposal connection

    If you recently installed a disposal, the drain knock-out plug may still be inside — pull it.

  5. 5

    Test the drain pump

    Remove pump cover under the filter housing. Spin the impeller by hand — sluggish or stuck = replace pump WD26X23258.

Recommended parts

  • Drain pump WD26X23258

    $60–$110

OEM matches verified by FixGrid AI. Affiliate links may apply.

Symptom

Leaking from the door / under the front

Door gasket, sump gasket, or overfill from a stuck float. Cheap parts, big impact.

Diagnostic flow

  1. 1

    Run a short cycle & locate

    Wipe the floor dry; run Rinse Only and watch with a flashlight where water emerges first.

  2. 2

    Inspect the door gasket

    Tug the U-shaped seal around the tub mouth — torn, hardened, or missing sections = replace WD08X10063.

  3. 3

    Check the float switch

    Lift the plastic float in the bottom-front of the tub — it should drop freely. Sticky = soak and clean.

  4. 4

    Confirm levelness

    A dishwasher leaning forward will leak under the door even with a good gasket.

Recommended parts

  • Door gasket WD08X10063

    $25–$40

OEM matches verified by FixGrid AI. Affiliate links may apply.

GE GDT695SSJSS — FAQ

How often should I clean the GE GDT695SSJSS filter?
Every 30 days for typical household use, or sooner if you scrape less aggressively. A clogged filter is the #1 cause of poor cleaning and drain faults.
What's the easiest fix for a GE Profile dishwasher that won't drain?
Pull and rinse the filter assembly. If standing water remains, check the high-loop on the drain hose and the disposal knock-out plug before replacing the pump.
Columbia, MD & nationwide

Beyond the DIY scope? Book a vetted local technician.

Family-operated coverage from Columbia, MD across Howard County, Baltimore, and the DC metro — plus a nationwide FixGrid technician network for everywhere else. 90-day warranty on every repair.

Book a local technician (443) 295-4865